Preparation before the trial run and the trial run start, and the trial run under the production conditions:A. Check whether the electrical performance and actions meet the design requirements.B.Check whether the water, air, and other pipes connected to the device are correct and leaky.C. Check the

Bottle washing clip This part acts as a whole is critical. When the bottle clip runs to the bottle, the clip 1 passively clamps the empty bottle, in the case of nylon to take over the 2 slug along the flip rail movement, the bottle mouth against the nozzle 3 > punch bottle, drain and then flip out

Matters needing attention during maintenanceA When cleaning, it is not appropriate to put water into the gears, bearings, seals and inside the workbench. Residual liquid on the paint surface should be scrubbed clean.B During the maintenance of parts, try not to damage the appearance of parts, seals

Recently some new friends came to inquire about our filling equipment​, and some of them asked if we are a manufacturer .